RGBeam — FLAGSHIP FLIP CHIP COB TECHNICAL BASELINE
RGBeam — 旗舰倒装 COB 技术基准

7,680 Hz — Minimum refresh rate
High-frequency LED driving for demanding motion content and camera-facing applications. Verify with the selected driver IC, scan mode and grayscale setting.
刷新率下限
高频 LED 驱动，适用于动态内容及镜头拍摄场景。须结合驱动 IC、扫描方式与灰阶设置验证。

ARMOR A10s — Minimum receiving-card class
NovaStar ARMOR A10s family or above. Use an HDR-capable A10s variant with the required firmware and compatible processor.
接收卡最低等级
NovaStar ARMOR A10s 系列或以上。采用支持 HDR 的 A10s 型号，并匹配所需固件及兼容的视频处理器。

16-bit + HDR — Minimum grayscale & HDR baseline
At least 16-bit grayscale processing, with HDR10 / HLG support through a compatible signal chain. HDR format and grayscale depth are separate specifications.
灰阶与 HDR 基准
至少 16-bit 灰阶处理，配合兼容的信号链支持 HDR10 / HLG。HDR 格式与灰阶位深为独立技术参数。

Flip Chip COB — Minimum flagship LED architecture
Flip-chip, chip-on-board packaging is the baseline for the RGBeam flagship COB platform. Pixel pitch and surface treatment are selected per project.
旗舰 LED 架构基准
RGBeam 旗舰 COB 平台以倒装芯片 COB 封装为基准。点间距与表面处理根据项目选定。

Pixel-level — Brightness & chroma calibration
Individual pixel calibration and stored coefficients are required in the flagship configuration for consistent module-to-module reproduction.
亮度与色度校正
旗舰配置要求逐点校正并保存校正系数，以实现模组间一致的画面表现。

RGB Gamma — Independent channel adjustment
Independent red, green and blue gamma adjustment is included in the system specification to refine white balance and low-grayscale performance.
独立通道调节
系统技术要求包括红、绿、蓝独立 Gamma 调节，用于优化白平衡与低灰表现。

Live status — Temperature & voltage monitoring
Receiving-card temperature and voltage monitoring are part of the specified control configuration for maintenance visibility.
温度与电压监测
所指定控制配置包含接收卡温度与电压监测，便于了解运行状态并安排维护。

Config backup — Firmware & calibration recovery
Configuration, firmware and calibration-coefficient backup form the minimum recovery plan. Physical signal or power redundancy is specified separately.
固件与校正恢复
配置、固件及校正系数备份构成基本恢复方案。实体信号或电源冗余需另行明确。

Scope: specified baseline requirements; verify the exact hardware and simultaneous refresh/grayscale configuration in the quotation and final datasheet. Specialty displays require separate specifications.
范围：本文件列明技术基准要求。确切硬件及刷新率与灰阶的同时实现条件，须以报价与最终规格书确认。特殊显示产品另行明确参数。

Reference for control-system capabilities (not RGBeam product certification):
https://oss.novastar.tech/uploads/2023/03/A10s-Pro-Receiving-Card-Specifications-V1.1.2.pdf